Mustang Survival MD3084 Manuale Utente

Owner’s ManualMD3081 Inflatable PFD Manual Inflation Model USCG Approved Type IIIMD3082 Inflatable PFD Manual Inflation Model with Harness USCG Ap

If this PFD should inflate prematurely, a re-arm kit (MA7202) is required to re-arm the device. IMPORTANT: The Inflatable PFD should be re-armed acc

Usage Below FreezingWhen the temperature is below freezing, a fully discharged cylinder may not adequately inflate your Inflatable PFD. Under these co

MD3081 and MD3082 Manual InflatorService IndicatorStep 5CylinderStep 2O-RingStep 3TabStep 4Sensor RingStep 3BayonetLeverFIGURE 84) Raise, and hold, t

TabPiercing PinCylinderLeverService IndicatorMD3081 and MD3082 Manual Inflator 1/8 TurnCylinder1/8 TurnTabPiercing PinLeverService IndicatorMD3081 and

removed prior to re-arming.5) Check the housing to be sure it is clear and dry. If necessary, rinse the inflator with fresh water to remove dirt and

unknown, check the date printed on the bobbin and replace if older than three (3) years (see Re-arming Your PFD (MD3083 and MD3084), p. 10).7) IMPORT

12) Refold the Inflatable PFD in accordance with the Repacking section (p. 13). YOUR INFLATABLE PFD (MD3083 and MD3084) IS NOW READY FOR MANUAL USE W

DCAEW1RW1RBBCADFFDCAEBBCADFFFDCABBCADEFPull-tabFIGURE 13FIGURE 14FIGURE 16FIGURE 15Sailing Harness Models with a sailing harness (MD3082 and MD3084) a

quick-release under-load hardware. This harness has not been designed for fall arrest, lifting or climbing and should not be relied upon in any of the

Repacking section (p.13). 3) Annually - Perform the following at the beginning of each boating season, after cell inflation, or whenever the integrit

Always store your Inflatable PFD in a warm, dry place out of direct sunlight.Cleaning and Storing of Your Inflatable PFD (MD3083 and MD3084)To clean y

MAINTENANCE INSTRUCTIONS for leak tests p. 14). It should inflate quick and easily.· Learn how it works by:   •ActivatingtheCO2 infla

is well above the water’s surface. Note the effect of where you hold your legs on how you float.5) Get out of the water and remove the Inflatable PFD

1) No spare parts or re-arming kits are needed to test an Inflatable PFD.2) Remove the CO2 cylinder/bayonet assembly to prevent inadvertent inflatio

hypothermia - a substantial loss of body heat, which leads to exhaustion and unconsciousness. Most drowning victims first suffer from hypothermia. The

Your will-to-live does make a difference!5) If there is more than one person in the water, huddling is recommended while waiting to be rescued. This

For the MD3081 and MD3082 - MA7203 Re-arm Kit – Contains 33-gram replacement CO2 cylinder/bayonet assembly for the manual inflator.For the MD3083 and

Mustang Survival and seahorse design is a registered trademark of Mustang Survival Corp.Our commitment to quality has earned our Burnaby facilities IS

CONTENTSPage 1 Approval Conditions and Carriage Regulations 2 What is an Inflatable PFD? 2 Instructions for Use 2 Component Inspect

DO NOT REMOVE PRIOR TO SALE. APPROVAL CONDITIONS AND CARRIAGE REGULATIONSThis Inflatable PFD is approved by the U.S. Coast Guard (USCG) for use as a T

WHAT IS AN INFLATABLE PFD?While traditional PFDs are inherently buoyant, inflatable PFDs, rely entirely on inflation for buoyancy. Uninflated, the Inf

MD3083 and MD3084 Service Indicator Automatic Inflator FIGURE 23) Ensure the oral-inflation dust cap is in the stowed position (Fig. 7).4) Ensure th

Your Inflatable PFD is ready for use if all applicable boxes are checked.NOTE: Contact your Mustang Dealer if you have any concerns about the readines

Inflating Your Inflatable PFDIt is recommended that the following procedures be followed to inflate your Inflatable PFD:1) Manual Inflation Activate

PFD, first locate the oral inflation tube by opening the wearer ’s left front panel of the Inflatable PFD. Remove the dust cap from the end of the ora